American Precision Tool & Engineering Terms And Conditions Continued. 

For Processing Suppliers, The Following are Minimum Requirements. 

 

QA13: Precessing suppliers must furnish processing certifications to the purchase order requirements, and shall not process any parts for which they are not certified or approved. Nadcap and or other specifications approval are required. Acceptable quality system requirement are AC7004 or  ISO9001,  or AS9100 any revision. QA3, QA4, QA5, QA6, QA8, QA9, QA10, QA11 QA12. 

 

For Raw Material Suppliers, The Following Are The Minimum Requirements. 

 

QA14: Raw Materials suppliers must furnish COA to the purchase order requirements, and shall not supply material for which they are not certified or approved. When noted on our purchase orders, raw material suppliers must use USA domestic material or its equivalent. Acceptable quality system requirement are AC7004 or ISO9001, or AS9100 any revision. QA3, QA4, QA5, QA6, QA8, QA9, QA10, QA11 QA12.

 

For Chemical Blending Suppliers, The following Are The Minimum Requirements.   

 

QA15: For Chemical Blending suppliers QA2-QA12 are applicable.  

 

For Calibration/Testing Suppliers, The following Are The Minimum Requirements.    

 

QA16: Calibration/test suppliers must furnish calibration/test reports according to the purchase order requirements, and be traceable to the specific
equipment or item for which they are calibrating/testing and must follow NIST and/or other national or international standards such as
IS09001 :2008, ISO 17025, Nadcap testing, ANSI z540, and/or Navlap accreditation will be the quality system requirements. Actual data
must be supplied. QA 3, QA 4, QA 5, QA 6, QA 8, QA 9, QA 10, QA 11, QA 12

 

All suppliers must comply with the basic Quality Clauses. Additional Quality clauses will be noted on the Purchase Order as applicable.

 

F 7.4.2-1 Rev. A                                                                     Page 2 of 2